How to Care for an Electric Onahole: Cleaning the Body, Powered Components, and Removable Parts

Electric onaholes have a motor, battery, and charging terminal, so you can't always wash them the whole way through the way you would a typical manual type.

One thing worth being especially careful about: don't assume “waterproof” and “washable” mean the same thing. Depending on the product, only a removable sleeve may be washable, the body itself may only take a wipe-down, or the entire body may be fully washable.

This article covers the basic approach to caring for an electric onahole, and what to watch for when handling the body, the powered components, and any removable parts.

Check the Instructions and Waterproof Range

Before washing, check the manufacturer's instructions or the product page for how far you can safely get it wet. Points worth confirming:

• Can the whole body be washed with water?
• Is it fully waterproof, or just splash-resistant?
• Can the sleeve or internal parts be removed?
• What cleaning agents can be used?
• How far can it safely be taken apart?

See the article below for more on the types and structural differences of electric onaholes.

Turn It Off and Unplug It Before Washing

Before you start cleaning, turn the power off and unplug the charging cable if it's connected. Avoid touching the charger or an outlet with wet hands. Don't connect or charge it while moisture remains on the charging terminal.

Some products come with a safety lock or a disassembly mode. Don't force it open or take it apart further than the manufacturer intends.

Remove a Detachable Sleeve and Wash It Separately

For products with a removable sleeve or internal parts, you can often separate them from the powered components and wash them on their own. The basic washing process is the same as for a regular onahole.

See the article below for a detailed walk-through of general washing, drying, and storage steps.

Don't Submerge the Powered Components

Unless the manufacturer specifically states that the body is fully waterproof, avoid submerging the powered components in water.

To clean surface grime, follow the manufacturer's instructions and wipe it down with a well-wrung, soft cloth. Afterward, remove moisture with a dry cloth and let it dry thoroughly.

Pay particular attention to keeping moisture out of these areas:

• The charging terminal
• The USB port
• The battery compartment
• Around buttons and switches
• Air intake/exhaust openings
• Where parts connect

Confirm the Charging Port Is Dry, Even on Waterproof Products

Even for products where the whole body is washable, charging it while water droplets remain on the terminal risks a malfunction. After washing, check inside the cover and around the terminal, and confirm no moisture remains before charging.

Don't Leave Moisture in Deep-Interior Types

Even with electric types, products with a deep sleeve or a large body tend to hold moisture deep inside. Rather than scrubbing the interior hard, drain it entrance-down and use an absorbent item unlikely to damage the material to remove moisture, then let it air-dry.

See the article below for washing and drying large products.

Only Reattach Washed Parts Once Fully Dry

Only put the sleeve back on the body once you've confirmed it's completely dry all the way through.

Reattaching it to the powered housing while still damp can lead to odor, mold, corroded terminals, and malfunction.

Also, applying hot air from a hair dryer or a heater to speed up drying can deform the material or damage the adhesive joints. The rule is natural drying in a shaded, well-ventilated spot.

Care Methods to Avoid

An electric onahole is essentially an electrical appliance like any other. Avoid the following when caring for it:

• Submerging the body in water without confirming the waterproof range
• Charging it while still wet
• Forcing open parts that aren't meant to come apart
• Letting cleaning agent get into the motor housing
• Washing it with boiling water
• Drying it with hot air from a hair dryer
• Using alcohol or strong bleach

Check the instruction manual and prioritize the method the manufacturer specifies.

Check Its Condition Before Use Too

Care isn't just about after use - checking its condition before use matters too. Confirm the power turns on, there's no unusual noise, the parts are fitted correctly, and the charging terminal isn't wet.

If you notice unusual heat, a burning smell, or strange noise during operation, stop using it and check the manufacturer's guidance.

Keep Washable and Non-Washable Parts Separate in Your Mind